freezing with kernel 2.6.26

Hello all,

i have big problems with the orinoco usb-card on 2.6.26-Kernels. The system freeze, so that you have
to use the reset-button, or in some less times it continues with segmentation faults.

I can't produce the error. It just happen after some seconds or minutes after the orinoco card is
switched on. During the installation with just a minimal system without X the card runs for hours
without problems (during the installation of the rest of the system), so it seems to have to do with
a conflicts to some oter stuff.

I used the rev. 1300 of orinoco_usb

I use the orinoco card some times with another computer (eeepc) on wich also runs the 2.6.26-Kernel,
but there are no problems at all.

I went now back to the old-stable kernel 2.6.18 and the rev. 1273 to avoid the problems, but I want
to report the problem here.

Regards.

Here is what said dmesg, when the error happend without freezing the whole computer:

[  991.876002] usb 4-2: new full speed USB device using ohci_hcd and address 4
[  992.042274] usb 4-2: configuration #1 chosen from 1 choice
[  992.044282] firmware: requesting orinoco_ezusb_fw
[  992.515196] eth1: Hardware identity 0001:0004:0005:0000
[  992.517199] eth1: Station identity  001f:0001:0008:0048
[  992.517202] eth1: Firmware determined as Lucent/Agere 8.72
[  992.517204] eth1: Ad-hoc demo mode supported
[  992.517206] eth1: IEEE standard IBSS ad-hoc mode supported